HERO D23, Руководство пользователя

Страница: 14 / 52

MANL-00005-A - D Series Rotary Dispensers.docx
14
Assembly
Refer to the Identification section of this manual to assist with part determination and placement.
1. Prepare an adequate working area to assemble the dispenser.
2. For counter top models, skip to step 6.
3. Place floor stand base assembly into desired location, ensuring base is level.
4. Attach support legs to base of cabinet. Support legs should extend out the front of the base and
away from each other. Secure with provided screws.
5. Place adjustable tray into shelf rails noting the arrows on the nylon guides are pointing up.
6. Install the counter top assembly on to the floor stand and secure with the four screws supplied.
7. Remove the crankshaft and the turntable nut from the center swivel body.
8. Place the turntable onto the swivel body, with the rolled edge of the turntable facing down.
NOTE: Ensure that the turntable rotates freely on the small step on the swivel and not on the threaded
portion of the swivel. Brake should be engaged in the “J” slot to allow constant rotation.
9. Install turntable nut and tighten.
10. Install the pre-lubricated crankshaft complete with nylon washer into swivel body. Ensure the
crankshaft fits completely over the motor’s square drive shaft. The motor drive shaft extends from
inside the floor stand up into the center of the swivel. When positioned correctly the crankshaft
will rest directly on the swivel.
11. Place the drive plate onto the crankshaft, ensuring the crankshaft rotating arm is correctly located
in the center bearing of drive plate. Take note of the “This side up” sticker on the drive plate.
12. Place drive cover over the drive plate.
NOTE: Drive cover must be installed prior to mounting canisters.
13. Rotate turntable until one drive plate arm and a canister mounting location are in line with one
another.
14. Align the canister ensuring that the paddle drive shaft is engaged in the hole of the drive plate
bushing at the end of each arm.
NOTE: The drive plate turns in an oscillating pattern, rather than a circle.
15. With the canister correctly positioned, secure from below the turntable with provided screws. Do
not overtighten.
16. With one canister secured to the turntable, move to the position directly across from it and secure
a second.
17. Continue mounting canisters, rotating the turntable as required.
18. When all canisters are attached, gently rotate turntable. Ensure all paddles are rotating freely and
no binding or chattering is evident.
NOTE: If the paddles fail to complete an entire rotation, the canister drive shaft may not have been
correctly installed in the drive plate. Remove canister and correct.
19. Plug in unit.