Operation Manual
BinTrac Breeder Control Operation Manual
Ver. 1.01 Rev 1.04
11
Part # MAN-000008
Operation
Select Weight Display
Press the SELECT key to select between Gross weight and Batch amount. The Gross Weight
is the total material remaining in the bin. The bar graph indicates the approximate level of the
bin. The Batch amount is remaining weight left to batch to reach the Batch Target. Note: Batch
Weight always starts at the Batch Target
and counts down to “0” weight. This provides the best
means to display the amount left to batch.
Manual Batch Run
1. Press
key until “
bAtch
”
is displayed.
2. Press SELECT to view the Batch Target Weight value.
3. Use the
key to increase the value by 1.
4. Use the
key to decrease the value by 1
5. Press SELECT to display the batch run control
status ( “
run
” or “
Stop
” )
6. Use the
or
keys to enable or disable batch run control.
7. Press SELECT to start Batching if run was selected. The batch run will begin immediately.
Scheduled Batch Run
1. Press
key until “
bAtch
”
is displayed.
2. Use the
key to select “
SchdL
”.
3. Use the
key to select hour and minute to schedule batch.
Note: This is a 24 hour clock. ie. 13:00 = 1:00 p.m.
4. Press SELECT to view the Batch Target Weight value.
5. Use the
key to increase the value by 1.
6. Use the
key to decrease the value by 1
7.
Press SELECT to display the batch run control status ( “
run
” or “
Stop
” )
8. Use the
or
keys to enable or disable batch run control.
9. Press SELECT
with “
run
” displayed. The Indicator will then display the batch amount and a countdown to the
next batch run.
10. To stop a scheduled batch run use the
key and “
StOP
” will be displayed. Press the SELECT key once to
stop and again on the batch amount. The Indicator will then return to display the gross amount in the bin.
