Heras HGD230, Руководство пользователя

Страница: 65 / 146

EN – Translation of the original user manual - 2.1 | 2019 65
The setting of the 4 DIP switches of the JCM receiver is: "On, Off, Off, On". The
No-Touch function for the closing movement can be set via the output relay Rel5
on the backplane as follows:
•
Switch off the power supply to the motor drive.
•
Connect the two contacts "INH" and "GND" of the JCM receiver CAP R868
/ 916 to the right and left contacts of the relay contact Rel5 as shown in
the drawing.
•
Switch on the power supply to the motor drive
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: „Settings“, „Safeties“, „JCM NTouchONLY “.
•
Menu: „Settings“, „In-/Outputs“, „OUT Rel5“: set to „28“.
•
Exit menu.
•
Check that the safety protection devices have been connected correctly
and check the reaction of the gate in the relevant movement direction in
automatic mode.
The radio transmitter for the information of the moving anti-crushing device on
the gate must be carefully installed, adjusted and tested according to the
description provided.
7.3 LEARNING THE END POSITIONS OF THE GATE
The motors of the Heras drive have an incremental encoder module. No further
limit switches are required on the gate. When installing and setting the gate and
the drive, the end positions of the gate are laid down, if present through the
buttons on the backplane, as follows:
•
Switch on the power supply of the motor drive.
•
Lock the motor and send it to the CLOSED position by use of the dead
man’s key button.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Press "Settings", "End positions", "Set CLOSED pos.". The motor drive
performs a reset.
•
Use the dead man's keys to move the gate to its part open position.
•
Press "Settings", "End positions", "Set part OPEN". The motor drive
performs a reset.
• Use the dead man's keys to move the gate to its open position.
• Press "Settings", "End positions", "Set OPEN pos.". The motor drive
performs a reset.