Hensel-Visit Expert D 1000, Руководство пользователя

Страница: 63 / 76

Servicing the device
63
Replacing a defective model lamp
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.

Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
To replace a defective model lamp, proceed as follows:

Switch off the device at the main switch.

Remove the mains cable (see page 33).

Remove the light shaping tool (see page 31).

Remove the protection glass (see page 30).

Replace the model light (see page 28).

Mount the protection glass (see page 30).

Mount the light shaping tool (see page 31).

Connect the mains cable (see page 33).

Switch on the device at the main switch.