Henny Penny Velocity OXE-100, Инструкции по эксплуатации

Страница: 86 / 118

T
roubleshooting
74
9 9..3 3 E Errrro orr C Co od de ess
In the event of a system failure the control board displays an error message. These messages are
coded as E which represents an error, a number designation and error message, such as E-4 CPU
TO HOT. Also, a constant tone sounds. To silence the tone, press any of the product buttons. Use
the following table to interpret and correct an error code.
T Ta ab blle e 9 9--2 2 E Errrro orr C Co od de ess
Error Cause Correction
E-1 LOW OIL
IN POT
The top heating element
where the probe is lo-
cated is getting hotter
than it would if the ele-
ment were submerged in
oil.
If the Protection Probe monitoring function determines that the oil
level is too low—below the main probe—it generates an E-1 error
code and displays the message LOW OIL IN POT!, CHECK OIL
LEVEL. Fill the vat with oil to the full line. If the error persists call
for service.
E-4 CPU
TOO HOT
Control board
overheating.
Remove heat from the fryer, the control board is getting too hot.
Once the front panel cools down the controls should return to
normal operation. If the error persists call for service.
E-5 OIL TOO
HOT
Oil overheating. Remove heat from the fryer. Once the unit cools down, the con-
trols should return to normal operation. If the error persists call
for service.
E-6A MAIN
TEMP
PROBE
FAILED
(Open
Circuit)
Temperature probe
failure.
Turn the switch to off position, then turn the switch back to on. If
the error persists call for service.
E-6B MAIN
TEMP
PROBE
FAILED
(Shorted)
E-10 (A thru
Y)
High limit tripped. Reset the high limit trip. The reset momentary switch is below the
control panel heat vents, under the lip, above the condensation
tank (box). Perform a clean out, refer to 7.7 Clean-Out Mode ,
page 43 . If the error persists call for service.
E-15C
DRAIN
VALVE
ERROR
The drain valve doesn’t
fully closed.
Unclog the drain with a drain brush. If the error persists call for
service.