Henny Penny LVE-202, Техническое руководство

Страница: 68 / 115

Maintenance
56
Test Points Results
From 30 to 34. open circuit.
From 31 to 35. open circuit.
From 32 to 36. open circuit.
From 33 to 37 (coil). ohm reading 5 to 6.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m ma akke e cco on nn ne eccttiio on nss b be effo orre e a ap p--
p pllyyiin ng g p po ow we err,, tta akke e rre ea ad diin ng g,, a an nd d rre e--
m mo ovve e p po ow we err b be effo orre e rre em mo ovviin ng g m me ette err
lle ea ad dss.. T Th he e ffo ollllo ow wiin ng g cch he ecckkss a arre e p pe err--
ffo orrm me ed d w wiitth h tth he e w wa allll cciirrccu uiitt b brre ea akke err
ccllo osse ed d a an nd d tth he e m ma aiin n p po ow we err ssw wiittcch h iin n
tth he e o on n p po ossiittiio on n..
4 4))
With power reapplied and in a heat-up mode, check the power going to both
contactor coils. Power should be going to both contactors. If no voltage is found
going into the primary contactor coil, check wiring, high limit module, and
element switch. If no voltage at heat contactor coil, check wiring and
connections at PC board.
5 5))
7 7..1 12 2..2 2 R Re ep plla acce em me en ntt
If either contactor proves defective, replace as follows.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Label and remove only those wires directly connected to the contactor being
replaced.