Henny Penny LVE-202, Техническое руководство

Страница: 55 / 115

Maintenance
43
5 5))
Tape new power leads to old lead left in place and route to controls area at front
of fryer and connect to contactor.
6 6))
Align pivot blocks and heaters straight across front of fryer and snug screws.
Lower elements into vats and adjust each so no elements rub sides of vat. Make
sure wires are clear and element sense switches operate properly.
7 7))
Torque each heater retaining bolt to 70 inch pounds.
8 8))
Connect ground wires, install panel, restore power, and test operation of fryer.
7 7..7 7 B Brre ea akke errss
There are two breakers on the electric fryer which protect the filter pump. To reset
breaker, open the left door and push up on the plunger of the tripped breaker.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Support control panel bottom with one hand , loosen retaining screw at panel
top, slide panel down slightly to clear screw, push panel back up, then swing
panel top out and down.
7 7..7 7..1 1 C Ch he ecckko ou utt
1 1))
Pull wires from breaker. Using a multimeter or continuity light, check across
terminals, circuit should be closed. If not, replace the breaker.