Henny Penny LVE-202, Техническое руководство

Страница: 49 / 115

Maintenance
37
3 3))
Perform steps seven and eight of 7.4.1 Control Panel Replacement, page 36
7 7..5 5 H Hiig gh h T Te em mp pe erra attu urre e L Liim miitt S Syysstte em m
A thermocouple is attached to each element and senses oil temperature. if
temperature exceeds 425°F (218°C), a switch opens and shuts off heat to vat, and E-
10 error code is displayed. After oil temperature cools to a safe operating temperature
(15-20 minutes), high limit control must be manually reset. Reset switches are located
in the front edge of an electrical panel on the right side of the unit beside the JIB.
1 1))
Open the right door, depress the raised part of the rocker switch for the affected
well, and release switch. If high limit resets, the oil starts heating. If high limit
does not reset, perform following checkout procedure.
7 7..5 5..1 1 C Ch he ecckko ou utt
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Open right door and remove the JIB.
2 2))
Remove one screw and panel cover.
3 3))
Locate thermocouple wires from element and disconnect from high limit.
4 4))
Using a multimeter and the chart below, check the multivolt reading between the
thermocouple wires and compare with the chart of the J-Type thermocouple. If
the reading matches the chart, the thermocouple on the element is good and
continue onto the next step of checkout. If not, go to
7.5.2 Replacement, page
39 to replace the thermocouple.