Mobile Rope Measurement MSM 12
Henning GmbH
Page 16
2.0 / 3.2009
7.4.2.7
Set display units
The rope loads and total weights can be displayed in two different units. The unit
kilogram or tons respectively is preset. Alternatively you may change to the output in
the English weight unit pound and here you can select between short tons and long
tons.
This selection is permanently stored and after the restart of the load meter it is se-
lected by default.
Figure 12: Display unit setting
7.4.3
Rope load wizard
The rope load wizard will assist you in the uniform adjustment of the ropes. For this
purpose the wizard uses the current rope loads as the actual state and calculates a
new desired load for each rope. The changed load distribution in the ropes is already
taken into consideration when readjusting a rope. Due to a special calculating algo-
rithm it becomes possible that even after only one adjustment run all ropes bear the
same load. In addition, during each adjustment process the wizard searches for a
reference rope which does not have to be adjusted. The rope load wizard only be-
comes active for two or more ropes.
Figure 13: Rope load wizard
Tolerance field
