9.
Set the desired value using the cursor keys
▲
and
▼
and press Enter.
10. Press the cursor key
◄
to return to the menu.
11. Close the lid to start the vacuum cycle.
6.2.5.14 Jars (optional)
Fast program specially designed for vacuum sealing jars. Seal and soft-air phase are shut off
during this program.
During the cycle, the air is removed from the chamber until the set pressure has been reached.
During the fast decompression the lids are being closed. It can also be combined with liquid
control, if this is the case, set the values in the liquid control program (sensor-controlled).
To set the vacuum level, follow the steps below:
1.
Press the cursor keys
◄
and
►
and select the program Jars.
2.
Press Enter to open the menu.
3.
If Vacuum is not enabled, enable it. Press Enter and use the cursor keys
▲
and
▼
to turn ON
Vacuum. Press Enter.
4.
Use the cursor keys
▲
and
▼
to go to the value for the Vacuum and press Enter.
5.
Set the desired value using the cursor keys
▲
and
▼
and press Enter.
6.
Press the cursor key
◄
to return to the menu.
7.
Close the lid to start the vacuum cycle.
6.2.5.15 Seal
This is the time that the sealing wire and/or the cut-off wire are heated. The longer the time, the
more heat is transferred to the bag.
As an option, the machine can be equipped with a Seal 1-2 option. This means the seal wire is
activated separately from the cut-off wire. This way the cut-off wire can be activated a bit longer, to
cut through thicker bags.
To set the Seal option, follow the steps below:
1.
Press the cursor keys
◄
and
►
and select the program Seal.
2.
Press Enter to open the menu.
3.
Use the cursor keys
▲
and
▼
to go to the value for the Sealing Time and press Enter.
4.
Set the desired value using the cursor keys
▲
and
▼
and press Enter.
When Seal 1-2 is activated, the cut-off time cannot be set lower than the seal time.
5.
Press the cursor key
◄
to return to the menu.
6.
Close the lid to start sealing.
6.2.5.16 Soft-Air
This is the time that air is softly released into the chamber after sealing has taken place.
To set the Soft-air function, follow the steps below:
1.
Press the cursor keys
▲
and
▼
and select the program Soft-air.
Operation 45