17
EN
CHAPTER 5. ATTACHING DISCHARGE ELBOW
A. Connect waste elbow to the disposer (see 5A), pro-
ceed to step 6 and then connect bottom of the elbow
by tightening the slip nut (see 5B).
B. If you are connecting to a dishwasher, return to
section 2B. If not, make sure all plumbing connec-
tions are tight and in accordance with all plumbing
codes and ordinances. Run water and check for
leaks.
A. Line up disposer under mounting assembly. Guide
hopper projections into mount ring slots. Turn mount
ring about 1/4” to right so that disposer is tempo-
rarily supported (see 6A).
B. Turn mount ring and disposer until disposer elbow
lines up with trap (see 6B).
C. Turn mount ring to the right (counter-clockwise)
until it locks up tight. Tap the mount ring ears with
a hammer until the lock position is achieved. Hopper
projections must be to extreme left of mounting
slots (see 6C & 6D).
D. If mount ring is hard to turn, you may add a small
amount of petroleum jelly or liquid soap to hopper
projections. Run water and check for leaks.
rubber
gasket
5A
6A
6B
6D
5B
CHAPTER 6. CONNECTING DISPOSER TO MOUNT ASSEMBLY
projection
elbow
hopper projection in
“supported“ position
hopper projection
in “lock“ position
mount ring
trap
slot
Locking detail
6C
