HRMA-1206C
6 Zones Integrated Mixer Amplifier with USB/SD/FM
9
mode, and playback will start.
4.2. Rear panel
MUTE
~220-240V/50-60Hz
FUSE: F6AL250V
LINE1
MIC2
SERIAL N.
INPUT
OUT
LINE2
LINE3
MAX MIN
SP2
GND
GND
SP1
SP4
GND
GND
SP3
SP6
GND
GND
SP5
OUTPUTS (100V
RMS
)
FM ANTENNA
FM(75Ω)
MADE IN CHINA
Lorem ipsum
1
2
3
4
5
6
7
8
1. Mute Control
- This Trimmer adjusts muting function, that is the threshold
from which all audio sources (LINE1/2/3, MIC2, USB/SD/FM) are muted when
MIC1 audio level exceed it.
2. MIC2 input
- Connect here microphones at unbalanced 30-600 ohm with
1/4” phone plug (6,3mm). This signal is muted when MIC1 audio exceeds
mute threshold.
3. Line 1/2/3 Input
- You can connect here any Line-level stereo sources
(CD-players, DAB Radio Tuner, Mixers, Tablets, etc.). All these signals are mut
-
ed when MIC1 audio exceeds mute threshold.
4. Line Output
- Connect here any power amplifier, recording device, mixer or
other audio system.
5. Fan Slot
- This window assures good heat dissipation to HRMA-1206C ampli
-
fier.
Please be careful to not cover this slot, otherwise the equipment
could be damaged.
6. 6-Zone Output terminals
- Connect here your 100V speakers.
WARNING: Pay attention to line polarity when connect speakers to the
unit. Each output has positive terminal (SP1, SP2, SP3, etc.), and
negative terminal (GND).
7. AC Power Connector / Fuse Holder
- Connect power cord to a mains outlet,
paying attention that voltage is 220-240Vac/50-60Hz. Fuse holder allows the
user to change fuse. In order to prevent the risk of fire and damaging the