HRMA-1206C
6 Zones Integrated Mixer Amplifier with USB/SD/FM
6
2. GETTING STARTED
2.1. Unpacking
Thank you for purchasing your HRMA-1206C 6-Zones Mixer Amplifier. All units
have been rigorously tested before leaving the factory, This product is widely used
in schools, shops, bars, pubs, parks, parking lots, villas, and other places: it is the
ideal choice for public broadcasting. In order to facilitate your installation, com
-
missioning and use of this product, please read this manual before installation.
Carefully unpack the carton and check the contents to ensure that all parts are
present and in good conditions:
y
1x HRMA-1206C mixer amplifier
y
1x 19” Rack Ear Kit with screws
y
1x FM Tuner Antenna Cable
y
1x Stereo RCA cable
y
1x Power Cord
y
1x Remote Control
y
This User manual
If anything damaged during transport, notify the shipper immediately and keep
packing material for inspection. Again, please save its carton and all packing
materials. If the unit must be returned to the manufacturer, it is important that
the unit is returned in the original manufacturer’s packing. Please do not take any
action without first contacting us.
Our products are subject to a continuous process of further development. There
-
fore modifications to the technical features remain subject to change without
further notice.
2.2. First Start-Up
When starting up the stereo amplifier for the first time, please proceed as follows:
1. Turn down the volume of each source.
2.
Deactivate all 6-zones selection buttons.
3.
Connect the amplifier to a microphone and/or other AUX source.
4.
Turn on ON/OFF switch. The power indicator will light.
5.
Press at least one of the 6 zone buttons.
6.
Gradually increase the input level related to connected source (MIC1, MIC2,
Line1, Line2, USB, etc.) until you reach the desired volume. If you need to change
the wiring or installation, make sure to decrease all volumes to minimum and
disconnect power cord first.