HCA-60 PLAY
2x30W Mini Digital Amplifier with USB & BT
10
4. Mode Selection
: Press to browse among LINE and BLUE modes (USB and SD
modes automatically activate when insert the corresponding unit in the slot).
5. Play mode
: Press this button to activate skip among SINGLE, rAN, INtO, ALL
modes.
• SINGLE
: Current song will be repeated until you press STOP;
• rAN
: Random Playback of all tracks;
• INtO
: Plays around 8 seconds of each song as preview of all tracks;
• ALL
: The song list will be played from the beginning to the end continu
-
ously.
6. Balance
: Press this button to choose among 5 EQ curves: FLA (flat), POP, CLA
(classic), ROC (rock), JAZ (jazz).
7. Previous
: By pressing it you can skip to previous song.
8. Next
: By pressing it you can skip to next song.
9. Play/Pause
: Press it to play current song. By pressing it again, you temporari
-
ly pause playback. Press again to continue playing.
10. Volume Down
: By pressing it you can decrease BT/USB/SD volume. It ranges
from 1 to 32.
11. Volume Up
: By pressing it you can increase BT/USB/SD volume. It ranges
from 1 to 32.
12. Numbers
: You can directly recall a certain song by pressing the correspond
-
ing number in the list. Single or two-digit numbers are accepted.
5. OPERATION INSTRUCTIONS
5.1. LINE Mode
When the unit is connected to power supply, press POWER switch on rear panel
to switch the unit on. The amplifier will keep last used mode. Press MODE button
repeatedly until you reach Line Mode. The display will show LINE.
Connect your external line-level stereo source to the LINE IN RCA pair on rear
panel. You can adjust volume using VOL+ and VOL- buttons.