Bromyard Road, Ledbury
Hereford HR8 1NS
www.HHAdlEssentials.co.uk
Fig.2
Fig.3
Adjuster Knob
Fig.4
Fig.1
Adjuster
Knob
Fixing
Bracket
Rubber
Buffer
Fig.5
Fitting Guide
Mark
Fitting Guide
Mark
KINGFISHER BATHBOARD
Part No: HA0680 and HA0686 (with handle)
Max. Safe user weight 200kg (31 stone)
The Kingfisher Bathboard is designed to make
getting in and out of the bath easier and safer.
The Bathboard can also be used for showering.
Assembling the fixing brackets to the Bathboard:
Four fixing brackets fit into outer slots on
the underside of the Bathboard (fig.1).
Hold the adjuster knob on the bracket and
Fit the head of the angled bolt through
the 'D' shaped hole at the end of the slot
(fig.2). ensuring that the bolt fits flat onto
the shoulders of the slot, with the rubber
buffer facing outwards. Slide the brackets
towards the middle of the board.
Positioning the Board in the bath:
Place the Bathboard on top of the bath with the handle and/or soap
dish on the wall side. Ensure that the area around is clean and ideally
the board should be at the opposite end to the taps (fig.3).
Slide the brackets out to the side of the bath. Check the position of the
Bathboard and then tighten up each adjuster knob to lock the brackets
in place (fig.4). Take care not to overtighten the adjuster knobs.
Please ensure that the fitting guide marks are over the supported
area of the bath tub sides (fig.5).
Check that the board is secure before every use.
