TB20, strain gauge weighing module | Edition 1 | 21.12.2018
18
3.3
Installing and removing peripheral modules
3.3.1
Installation
Installing an assembled peripheral module
Place the assembled module on the DIN rail by moving it straight towards the rail. Make sure that the
module engages the upper and lower guide elements of the previous module. Then push the upper
part of the module towards the DIN rail until the rail fastener inside fastens into place with a soft click.
Installing the individual parts of a peripheral module one after the other:
Place the base module on the DIN rail from below in an inclined position. Then push the upper part of
the base module towards the rail until the module is parallel to the rail and the rail fastener on the
inside snaps into place with a soft click.
Place an electronic module with matching coding (see the “Module coding” section on page 16) on
the base module in a straight line and then gently push it onto the base module until both modules
are fully resting on top of one another and the module fastener snaps into place with a soft click.
Finally, place the front connector on the electronic module from below in an inclined position and
then gently push it onto the electronic module until the front connector fastener snaps into place
with a soft click.
