2
360113-1
UltraCW™ Automatic Cell Washing System Service Manual
2
Reviewing information about
your cell washer
This section explains how to find identification information about your cell washer.
2.1
Finding model and input power information
The Product Specification label is located on the right side of the cell washer next to the power connector.
A
B
C
Type: UltraCW
Serial Number 0000000
Volts Freq Amps Power
110-127Vac 60 Hz 2.5 200 Watts
Kinetic Energy Max. Density RPM
250Nm 1.2Kg/dm 3500R/min
3
Made in Switzerland
2005
www.helmerinc.com
Noblesville, IN USA
Product Specification label (sample)
Label
Description
A
Type (Model)
B
Serial number (S/N)
C
Power requirements
2.2
Finding software and part version information
The software version appears on the control panel when you turn on the power.
Additional information is available through the Global menu, as follows:
Parameter
Meaning
CONTROL: XXX h
Number of operating hours
VERS XX °C/* 00
XX is the software version
FU/CCI - 1001
Frequency converter type
FU/CCI - S. XX.XX
Frequency converter software version
To view version information in the global menu
1
On the control panel, press and hold the parameter selection button (
) for about eight seconds until
VOLUME ADJUST XX appears on the message screen.
2
Press and release the parameter selection button (
) to cycle through the global parameters.
3
Exit the Global menu by pressing the STOP button or by not pressing any of the buttons for
approximately 16 seconds. The message screen returns to display mode for the selected program.
