Helion Avenge 10MT XLR, Руководство пользователя и техническая информация

Страница: 19 / 38

19
1. 25%: This is the lowest setting and should only be used when driving with
slow motors and on loose (low traction) surfaces.
2. 50%: It is not recommended to go below this setting on asphalt surfaces
as the stopping power may not be enough to safely slow your vehicle.
3. 75%: This is the default setting we feel will provide you the best starting
point for many different levels of traction on various surfaces. Remember
it is extremely important to only drive a vehicle as fast as you can safely
stop it. If the vehicle hits something or someone it can cause serious
injury.
4. 100%: This setting is only recommended if you are running a slotted type
motor.
Reset to Factory Defaults
At any time when the throttle is located in neutral zone (except in the throttle
calibration or programming mode), hold the SET key for over 3 seconds;
the red LED and green LED will flash at the same time indicating that each
programmable item has been reset to its default value.
Programming Chart
Use the chart on the next page, to better understand the programming
process. This should help you navigate through the programming menu.
WARNING: BE SURE TO CHECK YOUR MAXIMUM BRAKE SETTINGS BY DRIVING
FROM FULL THROTTLE TO FULL HARD BRAKE IN AN OPEN AREA. IF THE REAR
TIRES COME OFF THE GROUND CAUSING A FRONT FLIP, THE VEHICLE WILL
TUMBLE OUT OF CONTROL AND COULD CAUSE PERSONAL OR PROPERTY
DAMAGE.