Hekatron FSZ Pro, Инструкция по эксплуатации

Страница: 36 / 48

36
11 Commissioning and acceptance
11 Commissioning and acceptance
11.1 Acceptance testing according building type approval
After a hold-open system has been installed ready for operation at the place of use, its proper
function and installation according to instructions must be verified in an acceptance test.
The applicant for the general building type approval must point out that this test must be
performed. The test must be initiated by the owner/operator.
The acceptance test of hold-open systems at fire barriers may only be carried out by qualified
personnel of the applicant for the general building type approval or by qualified personnel
authorised by said applicant or by qualified personnel of a testing centre accredited by the DIBt
(German Institute for Structural Engineering) in the course of the general building type approval
procedure.
The acceptance test must at least include the following items:
1. It must be verified that the built-in devices and device combinations of the hold-open system
correspond to the devices and device combinations specified in the general building type
approval.
2. It must be verified that the labelling of the built-in devices and device combinations corresponds
to the labelling specified in the respective general building approval or standard.
3. The cooperation of all devices and device combinations must be verified according to the
general building type approval, wherein the devices must be triggered both by simulating the
characteristic fire value underlying the functional principle of the detectors and by hand.
4. It must be verified that the closure is enabled for self-closing as soon as the hold-open system is
no longer functional (e.g. due to removal of a detector or failure of the energy supply).