7. Now point the Remote Control unit at the device and test to see if it reacts to the Universal
Remote Control.
8. If the programming fails to work with the first code number on the code list, repeat steps 1 and
7 with the second code number.
Important! It may be that several codes work for the same device. If only some of the functions are
available via the Universal Remote Control unit, try using one of the other codes.
9. In order to quit the programming menu, press the EXIT key twice.
5. Learning function
After you have programmed the Universal Remote Control unit, you may notice that one or more
buttons which were available on your original remote control are missing from the 10000012
keypad or that they are assigned to a different function. For this reason the 10000012 is equipped
with a special learning function which enables you to transfer all of the keys from your original
remote control to your new Universal Remote Control unit.
5.1 Learn Key (Learn Key)
This remote control unit is capable of learning a total of 100 keys for 8 different devices. In doing
so, any of the keys can be used with the exception of the device selection keys (TV, VCR etc.),
SHOWVIEW, MACRO, SET, LEARN and ALL OFF.
Attention! Ensure that the original remote control works correctly and that neither the 10000012
nor your original remote control unit is pointing at the end device (e.g. the TV).
1. Lay the original remote control and the 10000012 on a level surface, so that the infrared
diodes on the remote control units are positioned approx. 2 to 5 cm apart from each other (see
fig. 1).
2. Use the device selection button (e.g. TV) to select the device which you intend to operate with
learnable keys on the 10000012.
3. Press and hold the LEARN button for approx. 3 seconds.
or
Press and hold the SET button for approx. 3 seconds until the system menu appears.
Navigate with the
▲
and
▼
buttons to the LEARNING menu item and subsequently press the
OK button, so that the LEARN KEY menu item is shown on the display.
4. Confirm the menu item by pressing the OK button again. The SELECT KEY message is now
shown on the display. Press the desired button on the 10000012 which is to be re-assigned
(e.g. MUTE). WAITING appears on the display for approx. 20 seconds. During this time, the
10000012 is in learning mode and will wait for the keyed command from your original remote
control.
Note! You cannot exit the system menu during the duration of the learning mode, in this case you
have to wait 20 seconds!