3. Changing / inserting batteries
The Universal Remote Control unit requires 2 Micro/AAA batteries (not included). The battery
should be replaced as soon as the battery icon appears!
1. Open the battery compartment cover on the rear side of the remote control unit.
2. Insert the batteries according to their correct polarity (+/-).
3. Close the battery compartment cover again.
Important! It is not necessary to reprogram the remote control unit subsequent to exchanging the
batteries. It is only necessary to reset the current time (see point 7.1).
4. Programming the Universal Remote Control (CODE Setup)
You can program the Universal Remote Control unit with the help of the integrated manufacturer
list, use the automatic search function, or enter the code numbers manually. The integrated
manufacturer list details all well-known manufacturers and the corresponding device codes can be
easily selected. The Universal Remote Control automatic programming system automatically
searches for the required device codes. Please enter the device code as listed in the code list for
manual programming. The Universal Remote Control uses the pre-set codes.
Attention! Before programming, ensure that the code number that you want to change has been
released. Please refer to the additional information under point 7.3.
4.1 Programming with the integrated manufacturer list
This function enables you to select the code number from the manufacturer list.
1. Switch on the device that you want to control with the Universal Remote Control unit. If the
device happens to be a video recorder, insert a video cassette and switch to "PLAY" mode.
2. Press and hold the SET button and simultaneously press the device selection key (e.g. TV) of
the code number that you want to program. You will now automatically enter the manufacturer
list.
3. Navigate to the device manufacturer with the help of the
▲
and
▼
keys.
Note: Pressing the
▲
or
▼
buttons for an extended period (approx. 4 seconds) causes the navigation
speed to be increased!
4. Subsequently select the first or additional code number (insofar as factory-programmed) by
means of the
◄
and
►
keys.
5. Now point the Universal Remote Control unit at the device and test to see if it reacts to the
Universal Remote Control. If the programming fails to work with the first code number on the
code list, repeat steps 4 and 5 with the second code number.
Note: You can test all of the buttons with the exception of the direction and function keys (
▲▼◄►
OK EXIT).
Important! It may be that several codes work for the same device. If only some of the functions are
available via the Universal Remote Control unit, try using one of the other codes.
6. Subsequently confirm your entry with the OK key. SUCCESS appears on the display for
approx. 1 second, subsequently the menu exits automatically.
7. If you want to abort the programming procedure, please press the EXIT key.