STRATA HEIKO PETITE V1 Oct 2019
Page
1
of
4
STRATA HEIKO PETITE
The Advanced Art of Towel Warming
WARNING:
This appliance is intended only for drying textiles washed in water.
WARNING:
In order to avoid a hazard for very young children, this appliance should be installed so that the
lowest heated rail is at least 600 mm above the floor.
IMPORTANT:
A means of disconnection in the fixed wiring must be used, which is in accordance with national wiring rules
(ie AS/NZS3000)
Insulation must not cover transformer (WTS12-100 supplied separately)
Operation
Your STRATA HEIKO PETITE Towel Warmer uses only minimal electrical power
–
about the same as an LED lamp. It will
take approximately 20-30 minutes to reach maximum operating temperature. STRATA HEIKO PETITE Towel warmers are
designed for continuous operation. NOTE: The temperature of your towel warmer will vary with the ambient temperature of
your room. A towel warmer is designed to warm and assist the drying of towels and will normally operate at a temperature
that is too hot for the warmer to be grasped for an extended time.
Locating Instructions
Detailed installation instructions are provided on the reverse side. The STRATA HEIKO PETITE Towel Warmer should be
fixed through the wall cladding directly to studs or other suitable anchor material. The towel warmer should be located in
compliance with the AS/NZS 60335 Standard . STRATA HEIKO PETITE 12V towel warmers have an IP47 rating offering
you the greatest flexibility to safely locate the towel warmer in bathrooms or shower rooms in
Zone 1-3
. All other electrical
fittings must also be compliant with the zone within which the warmer is being installed.
Electrical Installation
Ensure that your towel warmer is installed by a registered electrician and that the electrical supply switch location and
product location will comply with your local regulations.
New Zealand electrical wiring requirements stipulate that this appliance must be wired by a registered electrician in
accordance with current electrical wiring regulations. This appliance must be fitted with an air gap phase isolation switch
which isolates the phase & neutral in accordance with local wiring regulations.
This product must be used in conjunction
with a hard wired switch
. For complete temperature control a wall mounted dimmer sw
itch (with “off” position) is
recommended.
Concealed Wiring
This model is designed for concealed wiring only. Access to the wall cavity before cladding is installed is essential to install a
draw wire .
Care and Cleaning
The polished stainless steel finish of your Towel Warmer is hard wearing and easily maintained. Clean regularly with a soft
cloth and non-abrasive cleaning agent. Black finish is more sensitive to scratching and care is required when cleaning.
Warranty
This product is warranted against defects due to faulty workmanship or materials for 10 years from date of purchase. In the
event of a defect in the product, turn it off at the wall, and contact the retailer from which it was purchased and provide
details from your sales receipt and the products serial number from the label on the towel warmer. The retailer will contact
Heirloom who will assess the matter and if accepted as a valid warranty claim the product will be repaired or replaced at
Heirloom
’s option –
free of charge. Costs of disconnection, reconnection, and freight are the responsibility of the owner, as
is any damage arising in transit to and from servicing by Heirloom. This warranty does not cover:
a.
Any damage to the product caused by misuse, neglect, accident, or in
violation of the manufacturer’s instructions,
or
b.
Any damage, loss or injury arising as a consequence of the use of the product.
Australia: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to
a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are
