Heiniger 709-000 CH, Перевод оригинальной инструкции, Страница: 36 / 244

16
Translation of the original instructions / Small animal clipper
6.2.4 Lubrication
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (fig. 24).
CAUTION!
Unsufficient lubrication of the clipperhead causes heating and a reduced
durability of clipper and blades, as well as a reduction of the battery runtime.
Therefore:
X
Lubricate the blades sufficiently during the clipping (at least every 15
minutes), so that they do not drain (fig. 24).
X
Only use the lubricants prescribed by the manufacturer.
NOTE!
Only use our special oil or a paraffin oil
meeting the ISO VG 15 specification.
The provided oil is non-toxic and produces no irritation on contact with the
skin or the mucous membranes. This paraffin oil degrades to some 20%
after 21 days (CEL-L-33-T-82).
Fig. 24
The blades must be oiled before, during
and after every use. When the blades
of the clipper are leaving stripes, this is
a signal that oil is required. Place a few
drops of oil ahead and laterally on the
clipper blades (see arrows in fig. 24).
Wipe off the excessive oil with a smooth,
dry cloth. Lubrication sprays do not have
sufficient oil for a good lubrication, but
serve for cooling the blades. Immediate-
ly change damaged or crenated blades
to avoid injuries.
CAUTION!
Remove all the leaking, used up or excessive grease from all the lubrication
points, and it is to be disposed in accordance with the local regulations.
6.2.5 Cleaning
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (6.2.4 Lubrication).
Clipperhead and hinge
Clean clipperheads und hinge between the different clippings.