ASSEMBLY
1. Attach base sections to upright channels with 4 bolts and nuts.
2. Attach lower cross member to upright channels with 4 bolts and nuts.
3. Ensure bed frame at lowest position and winch cable is slack.
4. Install the winch assembly to the press using 3 bolts, washers and nuts.
5. Secure cylinder to the cylinder adapter plate, and mount the adapter plate to upper cross member with provided bolts,
washers and nuts.
6. Secure the pump bracket to the upright channel with bolts, nuts & washers provided.
7. Connect the pressure gauge and the hydraulic hose to the gauge adapter, then connect the gauge adapter to pump.
Important:
Ensure thread tape or compound is use on connections.
8. Place the pump on the pump bracket and connect the other end of hydraulic hose to cylinder.
8.a. When using manual pump, bolt pump to pump bracket.
Figure 1 - Typical Shop Press Components
Cylinder
Winch
Upright Channel
Support Pin
Base
Upper Cross Member
Manual Pump
Pressure Gauge
Bed Frame
Arbor Plates
Lower Cross Member
Air Pump for Model HW93301:
4
(Optional, not
included with
the press)
Before disassemble, slide bed frame section down, into its lowest position
.
!
Pump Bracket
(Model HW93300)
