HEIDENHAIN TNC 640, Руководство пользователя, Страница: 262 / 948

Tools | Tool data
6
262
HEIDENHAIN | TNC 640 | Conversational Programming User's Manual | 10/2017
Overtime for tool life
This feature must be enabled and adapted by the
machine tool builder.
The tool condition at the end of planned tool life depends on e.g.
the tool type, machining method and workpiece material. In the
OVRTIME
column of the tool table, enter the time in minutes for
which the tool is permitted to be used beyond the tool life.
The machine manufacturer specifies whether this column is
enabled and how it is used during tool search.
Prerequisites for NC blocks with surface-normal vectors and
3-D compensation
The active radius (
R
+
DR
) of the replacement tool must not
deviate from the radius of the original tool. You can enter the delta
values (
DR
) either in the tool table or in the
TOOL CALL
block.
With deviations, the control displays an error message and does
not replace the tool. You can suppress this message with the M
function
M107,
and reactivate it with
M108.
Further information: "Three-dimensional tool compensation
(option 9)", page 631