HEIDENHAIN TNC 620, Руководство пользователя

Страница: 360 / 521

MOD functions | Setting up touch probes
9
Touch probe with radio transmission configuration
In the
Set up touch probes
MOD function, the control displays
information on each touch probe at the right-hand side of the screen.
Some of this information is also visible and configurable for infrared
touch probes.
Tab TS 3-D touch probe TT tool touch probe
Work data Data from the touch probe table Data from the machine parameters
Project infor-
mation
Connection data and diagnostics functions Connection data and diagnostics functions
You can change the data from the touch probe table by selecting the
row with the cursor and overwriting the current value.
You can change the machine parameters only after first entering the
code number.
Changing properties
To change the characteristics of a touch probe, proceed as follows:
Place the cursor on the row for the touch probe
Select the “Properties” tab
The control shows the properties of the selected touch probe.
Change the properties as desired per soft key
You have the following options depending on the row on which the
cursor is located:
Soft key Function
Select the probe signal
Select the radio channel
Select the channel with the best radio transmis-
sion and pay attention to overlaps with other
machines or wireless handwheels.
Change the radio channel
Delete the touch probe data
The control deletes the entry from the MOD
function and the touch probe table or from the
machine parameters.
Save a new touch probe in the current row
The control automatically overwrites the serial
number of the replaced touch probe with the new
number.
360
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022