HEIDENHAIN TNC 620, Руководство пользователя

Страница: 302 / 521

Testing and running | Positioning w/ Manual Data Input operating mode
6
Example: Remove workpiece misalignment on a machine with a
rotary table
Use a 3-D touch probe to carry out a basic rotation
Further information: "Compensating workpiece misalignment
with 3-D touch probe (option 17)", Page 221
Write down the rotation angle and cancel the basic rotation
Select the operating mode: Press the
Positioning
w/ Manual Data Input
key
Select the rotary table axis, enter the rotation
angle and feed rate you wrote down, e.g.
L C
+2.561 F50
Conclude entry
Press the
NC Start
button: The rotation of the
table corrects the misalignment
Saving NC programs from $MDI
The $MDI file is intended for short NC programs that are only
needed temporarily. Nevertheless, you can store an NC program, if
necessary, by proceeding as follows:
Operating mode: Press the
Programming
key
Call the file manager: Press
PGM MGT
key.
Move the highlight to the
$MDI
file
Copy the file: Press the
COPY
soft key
DESTINATION FILE =
Enter the name under which you want to save the current
contents of the $MDI file, e.g.
Hole
Press the
OK
soft key.
To exit the file manager, press the
END
soft key
302
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022