HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 573 / 695

Program run 16.5
16
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
573
Interrupt, stop or abort machining
There are several ways to stop a program run:
Interrupt the program run with e.g. the miscellaneous function
M0
Interrupt the program run e.g. with the miscellaneous function
M0
Stop the program run e.g. with the
NC STOP
key in conjunction
with the
INTERNAL STOP
soft key
INTERNAL STOP
Terminate the program run e.g. with the miscellaneous
functions
M2
or
M30
The control shows the current status of the program run in the
status display.
Further Information: "General status display", page 84
The difference between an interrupted (terminated) program run
and a stopped run is that an interrupted run allows the user to carry
out the following actions:
Select operating mode
Check Q parameters and change these if necessary using the
Q
INFO
function
Change setting for the optional programmed interruption with
M1
Change setting for the programmed skipping of NC blocks with
/
If the control registers an important error during a
program run, it automatically stops the program run.
Example: Cycle call with stationary spindle