HEIDENHAIN TNC 620 Programming Station, Руководство пользователя

Страница: 199 / 695

Tool data 5.2
5
HEIDENHAIN | TNC 620 | ISO Programming User's Manual | 9/2016
199
Delta values for lengths and radii
Delta values are offsets in the length and radius of a tool.
A positive delta value describes a tool oversize (
DL
,
DR
>0). If you
are programming the machining data with an allowance, enter the
oversize value in the
T
.
A negative delta value describes a tool undersize (
DL
,
DR
<0). An
undersize is entered in the tool table for wear.
Delta values are usually entered as numerical values. In a
T
block,
you can also assign the values to Q parameters.
Input range: You can enter a delta value with up to ± 99.999 mm.
Delta values from the tool table influence the
graphical representation of the clearing simulation.
Delta values from the
T
block do not change the
represented size of the tool during the simulation.
However, the programmed delta values move the
tool by the defined value in the simulation.
Delta values from the
T
block influence the
position display depending on the optional machine
parameter
progToolCallDL
(no. 124501).
Entering tool data into the program
The machine tool builder determines the scope of
function of the
G99
function. Refer to your machine
manual.
The number, length and radius of a specific tool is defined in the
G99
block of the part program:
Select the tool definition: Press the
TOOL DEF
key
Tool number
: Each tool is uniquely identified by its
tool number
Tool length
: Compensation value for the tool
length
Tool radius
: Compensation value for the tool
radius
In the programming dialog, you can transfer the value
for tool length and tool radius directly into the input
line by pressing the desired axis soft key.
Example
N40 G99 T5 L+10 R+5*