HEIDENHAIN TNC 620 E, Руководство пользователя

Страница: 309 / 840

Programming Contours | Path contours – FK free contour programming (option 19)
7
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
309
FK programming graphics
If you wish to use graphic support during FK
programming, select the
P GRAPHICS
screen
layout.
Further information: "Programming", page 92
Incomplete coordinate data often is not sufficient to fully define a
workpiece contour. In this case, the control indicates the possible
solutions in the FK graphic. You can then select the contour that
matches the drawing.
The control uses various colors in the FK graphics:
blue: uniquely specified contour element
The last FK element is only shown in blue after the departure
movement.
violet: not yet uniquely specified contour element
ocher: tool midpoint path
red: rapid traverse
green: more than one solution is possible
If the data permit several possible solutions and the contour
element is displayed in green, select the correct contour element
as follows:
Press the
SHOW SOLUTION
soft key repeatedly
until the correct contour element is displayed.
Use the zoom function if you cannot distinguish
possible solutions in the standard setting
If the displayed contour element matches
the drawing, select the contour element with
SELECT SOLUTION
If you do not yet wish to select a green contour element, press the
START SINGLE
soft key to continue the FK dialog.
Select the green contour elements as soon as possible
with the
SELECT SOLUTION
soft key. This way you can
reduce the ambiguity of subsequent elements.
Showing block numbers in the graphic window
To show a block number in the graphic window:
Set the
SHOW OMIT BLOCK NR.
soft key to
SHOW
(soft-key row 3)