HEIDENHAIN GAGE-CHEK 2000, Руководство по эксплуатации

Страница: 81 / 250

Information for OEM and Setup users | Commissioning
4.5 Configuring a touch probe
You can use a touch probe to probe points. The stylus of the touch probe can be
additionally fitted with a ruby ball tip. In order to use a touch probe, you need to
configure the relevant parameters.
Settings
►
Sensors
►
Touch probe
Parameter Explanation
Touch probe
Activates or deactivates the connected touch probe for use
Setting range:
ON
or
OFF
Default value:
OFF
Diameter
Diameter of the touch probe
Setting range: ≥
0.0001
Default value:
6.0000
Evaluation of the ready signal
Possibility of setting whether the ready signal of the touch probe
should be evaluated, depending on the touch probe
Setting range:
ON
or
OFF
Default value:
ON
Use the touch-probe triggered output of measured values to
automatically send the measured values to a computer when the stylus
is deflected.
Further information: "Configuring the measured value output",
Page 234
4.6 Configuring the axes
The procedure varies depending on the interface type of the connected encoder:
Encoders with EnDat interface:
The encoder applies the parameters automatically
Further information: "Configuring axes for encoders with EnDat interface",
Page 86
Encoders with 1 V
pp
or 11 µA
pp
or TTL interface:
The parameters must be configured manually
For the parameters of HEIDENHAIN encoders that are typically connected to the
product, refer to the overview of typical encoders.
Further information: "Overview of typical encoders", Page 83
II
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 06/2022
81