HEIDENHAIN GAGE-CHEK 2000 Series, Руководство по эксплуатации

Страница: 47 / 236

Installation | Wiring switching inputs and outputs
5.6 Wiring switching inputs and outputs
Depending on the peripherals to be connected, the connection work
may need to be carried out by an electrical specialist.
Example: Safety Extra Low Voltage (SELV) exceeded
Further information: "Personnel qualification", Page 25
The product fulfills the requirements of standard IEC 61010-1 only if the
power to the peripheral devices is supplied from a secondary circuit
with current limitation as per IEC 61010-1
3rd Ed.
, Section 9.4 or with
power limitation as per IEC 60950-1
2nd Ed.
, Section 2.5 or from a Class 2
secondary circuit as specified in UL1310.
In place of IEC 61010-1
3rd Ed.
, Section 9.4, the corresponding sections
of standards DIN EN 61010-1, EN 61010-1, UL 61010-1 and CAN/CSA-
C22.2 No. 61010-1can be used, and, in place of IEC 60950-1
2nd Ed.
,
Section 2.5, the corresponding sections of standards DIN EN 60950-1,
EN 60950-1, UL 60950-1, CAN/CSA-C22.2 No. 60950-1 can be applied.
Wire switching inputs and outputs in accordance with the following pin layout
Remove and save the dust protection cap
Route the cables depending on the mounting variant
Further information:
"Assembly of the product", Page 36
Connect the connecting cables of the peripherals tightly to their connectors
Further information: "Device overview", Page 43
If the cable connectors include mounting screws, do not overtighten them
The digital or analog inputs and outputs must be assigned in the device
settings of the respective switching function.
5
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
47