HEIDENHAIN GAGE-CHEK 2000 Series, Руководство по эксплуатации

Страница: 132 / 236

Setup | Single steps for setup
8
Adding a function element
Tap
Measure
in the main menu
Drag an empty field of the Inspector to the left into the
workspace
A dialog box for selecting the function element appears
Tap the desired function element, e.g.
Determining the
circle center (probing)
Tap Close
The function element is available in the Inspector
Configuring a function
Drag the function element to the left in the workspace
Use the
ON/OFF sliding switch in the dialog to activate the
desired functions:
MVO : The measured value is automatically transferred to
the computer
Select preset : Once probing has completed, you can use
the acquired coordinates as preset
When using the
Determining the circle center
probing
function, select the plane of the circle via the drop-down
lists;
default: plane of the
X and Y axes
Tap
Close
The selection is saved
The product uses the data format for measured value output that is
selected for manual data transmission in the product settings.
Further information: "Selecting a data format", Page 143
8.3.4 Configuring the
MinMax
function
The MinMax function helps you to acquire the following measured values:
Minimum Maximum Range
You activate and deactivate the function by tapping the
MinMax
function element
in the Inspector. If the function is active, the measured values will be captured
and shown in the position display. You can then transfer the measured values to
a computer via the measured value output. If you activate the
MinMax function
again, then the existing measured values will be overwritten.
The following steps are necessary in order to configure the
MinMax
function:
Add the MinMax function element to the Inspector
Select measured values that are to be captured and displayed when the
MinMax function is active
132
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020