HEIDENHAIN 548431-05, Руководство пользователя, Страница: 419 / 722

ICP programming |
ICP editor
submode in Teach-in
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
419
6.2
ICP editor
submode in Teach-in
In Teach-in mode you can create:
Complex workpiece blank contours
Contours for turning
For ICP turning cycles
For ICP recessing cycles
For ICP recess-turning cycles
Complex contours for milling with the C axis
For the face
For the lateral surface
You activate the ICP editor submode with the Edit ICP soft key. It
can only be selected when editing ICP turning cycles or ICP milling
cycles or the ICP workpiece blank contour cycle.
The description depends on the contour type. Using the cycle,
ICP
distinguishes between:
Contour for turning or the workpiece blank contour:
Further information: "Contour elements – turning contour",
Page 449
Contour for the face:
Further information: "Front face contours in smart.Turn mode
of operation", Page 475
Contour for the lateral surface:
Further information:
"Lateral surface contours in smart.Turn
mode of operation", Page 485
If you create or edit two or more ICP contours in
sequence, the last edited
ICP contour number
is
loaded to the cycle after the ICP editor submode has
been exited.