HEIDENHAIN 548431-05, Руководство пользователя, Страница: 225 / 722

Teach-in | Turning cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
225
Traverse cutting, finishing plunge
Select
Roughing cycles lon/trans
Select Plunge transv.
Press the Finishing run soft key
The cycle finishes the contour area from Start point contour to
End point contour . At the end of the cycle, the tool returns to the
Start point .
The tool plunges with the maximum possible angle,
leaving material remaining
The steeper the tool plunges into the material, the
greater the feed rate decrease (max. 50 %)
Cycle parameters:
X , Z : Start point
X1
,
Z1
:
Start point contour
X2 , Z2 : End point contour
A : Plunging angle (range: 0° <= A < 90°; default: 0°)
W
:
Final angle
(range: 0° <=
W
< 90°; default: 0°)
G47 : Safety clearance
Further information:
"Safety clearance G47", Page 180
T
:
Tool number
– turret pocket number
G14 : Tool change point
Further information: "Tool change point G14", Page 180
ID : ID no.
S
:
Cutting speed
or
Constant speed
F : Feed per revolution
MT : M after T : M function that is executed after the tool call T
MFS
:
M at beginning
:
M
function that is executed at the
beginning of the machining step
MFE : M at end : M function that is executed at the end of the
machining step
WP
:
No. of spindle
– Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
BW
:
Angle in the B axis
(machine-dependent)
CW : Reverse the tool (machine-dependent)
HC : Shoe brake (machine-dependent)
DF
:
Miscellaneous function
(machine-dependent)
Type of machining for technology database access:
Finishing