HEIDELBERG e.GO Wallbox home, Руководство по установке

Страница: 15 / 60

Installation instructions
1 Column for "Heidelberg Wallbox Home Eco" and "e.GO Wallbox home"
1.1 Requirements at the site
● The site requirements for the Wallbox, which are
given in the installation instructions for the Wall‐
box, must be fulfilled.
● If the column is installed in a parking area or in an
underground car park, a suitable anti-collision
device must be provided.
● The site fabricator is responsible for calculating,
dimensioning, and fabricating the concrete foun‐
dation.
● The column must be installed on a flat, horizontal,
load-bearing surface. A concrete foundation is
recommended in order to provide secure and
permanent anchoring. Frost-resistant base, con‐
crete: C30/37 LP for XC4, XD1, XF4 respectively
C25/30 LP for XC4, XD1, XF2.
● After it has been secured to the foundation, the
column must be able to withstand a force of min.
500 Nm in all directions.
● The surface must allow drainage of any water
that penetrates the pedestal.
● Installation of the column on asphalt is not per‐
missible.
1.2 Electrical stipulations
● Single wires are not permitted to supply power.
● The supply line must be dimensioned for medium
to heavy loads. Practical examples:
○
PVC installation cables of type NYM,
○ PVC ground cables of type NYY,
○ H07RN-F heavy rubber cable.
● The sheath diameter of the connecting line must
not exceed 17 mm (max. cable diameter of the
cable entry gland of the Wallbox).
Ground connection in the column
●
The ground connecting bolts are used to connect
the column to the equipotential bonding system
at the installation site. The connection must com‐
ply with the respective national regulations. Rec‐
ommended minimum cross-section: 6 mm² for
copper and 16 mm² for aluminum. The resistance
must not exceed 1 ohm.
Types of cable routing
Cable routing via cable conduit or protective hose
through the foundation:
●
All cables must emerge from the floor exactly in
the middle of the concrete foundation within a
quadratic area of max. 50 mm x 50 mm. The ca‐
00.110.9717-000UTKENU_00
Installation instructions
A.1.1