HeatLink HEP025RT, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 20

This zone control panel can provide mixing, distribution, and zoning for a wide variety of hydronic heating
applications.
The eff ectiveness of the system is dependant on the system being designed and installed correctly. Proper
consideration of factors such as BTU loads, outdoor design temperature, indoor design temperature, room set-
point temperature(s), diff erential fl uid temperatures, head loss, fl ow rates, and transfer capacities of the heat
emitters is critical.
Once these factors have been considered and the system requirements determined, these can then be evaluated
and compared to the panel capabilities.
5
®
Heat Link
www.heatlink.com
HEP025RT
Installation, Operation, and Maintenance Manual
L6HEP025RT
Step 1
Examine carton for any damage that may have occurred during shipping. If damage is visible
notify your courier and supplier immediately.
Step 2
Open the carton by removing the staples.
Step 3
Remove the cardboard spacers from the carton, then remove the panel from the carton. Lift
the panel by the base, not the pipework.
Unpacking
Note: This panel does not regulate or monitor the operating safety limit temperatures of the fluid leaving
the heat source. Dependant on local codes, the HEP025RT panel may be suitable for application in either
open or closed systems supplied with potable water, where the system utilizes the domestic hot water as a
heat source for the hydronic system. In such cases, all components of the panel (and system components)
must be specified as non-ferrous material, suitably approved for potable use. Prior to installation consult
your Local Authority Having Jurisdiction to determine the suitability of such an application.
Note: The HEP025RT does not include a cover.
Function