heatapp! T2B, Инструкция по эксплуатации, Страница: 72 / 135

Functions of the room- and radio components
S. 72
2. Now press the learn key (1) in the middle below the display.
3. Check whether the heatapp! drive has been successfully registered on the heatapp! gateway.
If no connection can be made, then if necessary a heatapp! repeater must be used to improve wireless coverage.
11.2.3 Mounting heatapp! drive
Fig.: 50 Mounting heatapp! drive
Before installation a flashing "M" must be shown in the display.
1. Check whether one of the two supplied adapters matches the radiator valve.
2. Fit the heatapp! drive to the corresponding radiator valve in the allocated room. Screw the adapter onto the radiator
valve and then screw the heatapp! drive on to the adapter.
3. Press the learn key (1) for 3 seconds until the display goes out and the heatapp! drive audibly attaches to the valve.
11.2.4 Setting Setpoint temperature
Pressing the arrow keys causes the target temperature to be increased or lowered. The setting corresponds to the setting of the
target temperature using the rotary control in the
heatapp! app .
Local operation at the heatapp! drive can be switched on an off in the Expert Settings of the heatapp! base. To do so, select
“Settings

System

Expert”. Under System, it is possible to disable local operation for all heatapp! drives located in the
system, under Room

Room settings, local operation for just this room is disabled.