heatapp! T2B, Инструкция по эксплуатации, Страница: 31 / 135

Completion of the set-up
S. 31
8 Completion of the set-up
After the set-up is complete, create an establishment protocol and a backup. If you want to set up a single room control, create
the establishment protocol and the backup only after the complete installation of the
heatapp! gateway.
8.1 Establishment protocol
The establishment protocol (look also selection „Establishment protocol“) can be found in the heatapp! base menu. Click the
Establishment protocol button, and then click Create establishment protocol. After a few minutes, the system has created a
document from which you can view all parameters set.
Below the establishment protocol is the “Send by e-mail” button. Enter your e-mail address to send the establishment protocol
as a PDF file.
8.2 Data backup
The heatapp! base offers you the option to create a data backup (look also selection „System“ on page 59) on a USB stick. Click
the “System management” button. Insert a USB memory stick into a free USB port of the heatapp! base and create a data backup
by clicking the OK button.