27
®
Link
Heat
Link
Pure
®
Link Plus
3-in-1 Confined Space Press Tool Instructions
Multi Stage Press; 11435.
{
{
Regularly check tool jaws and sleeve
for any abnormalities that could be an
indication of a damaged tool.
{
{
If the Stainless Steel Sleeve is damaged or
pressed incorrectly, both the fitting and the
sleeve must be replaced.
{
{
The stainless steel press sleeve must
be completely pressed only one time. If
pressed more than once it is necessary to
cut out the fitting, and replace with new
sleeves and fitting.
{
{
Never reuse stainless steel press sleeves.
The 3-in-1 confined space tool features
a cam lever that modulates the
pressure applied to the press sleeve,
allowing for a Multi Stage Press.
Adjust the Cam Lever between Start
and Finish for easier presses on
large diameter PEX.
When the lever is in the Finish
position, it will not be able to
move any further.
Start
Finish
Lever
1. Pull back on
the moving (top)
handle to open the
jaws. Do not force the
handles apart - this can
damage the tool!
2. Position the jaws squarely around the
sleeve, then allow the moving handle
to return to the default position, which
will close the jaws over the stainless
steel sleeve (no pressure is applied by
this process).