Changing from the Standard Remote FAN61T-3SP to Universal Remote FAN61T-3SP1
To clear old codes, complete the process below 2 times
with the remote control.
Follow these instructions to
(1) Change the transmitter code if you have interference with
other fans and want to operate this fan only or
(2) Re-sync the transmitter code if your fan is not working
properly.
Step 1. Power the ceiling fan on.
Step 2. Install two 1.5-volt AAA batteries.
Step 3. Press the button located on the front of the transmitter
to operate the fan.
Step 4. Press the button to operate the light.
Note:
The blue light will illuminate to indicate the transmitter is
working.
REMOTE CONTROL OPERATIONS
Operate Fan Using Transmitter Code Pre-Set by Factory
Step 1. Switch off the power to the fan.
Step 1. Switch off the power of the fan.
Step 2. Switch on the power to the fan.
Step 2. Switch on the power of the fan.
Step 3.
Within 30 seconds
, switch the lock /unlock switch
on the back of the transmitter to the lock position and then
push the sync button for about 5-10 seconds until the fan
light kit flashes 3 times.
FCC ID: 2AAZPFAN61T3SP1 / I C : 11037A-FAN61T3SP1
This device complies with part 15 of the FCC Rules and RSS-210 Issue 8. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and
the limits pursuant to RSS-210 Issue 8.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or experienced radio /TV technician for help.
1
3 SPEED UNIVERSAL REMOTE CONTROL
ITM/PART NO.: FAN61T-3SP1 WHT
Step 3.
Within 30 seconds
, switch the lock /unlock switch
on the back of the transmitter to the lock position and then
push the sync button for about 5-10 seconds until the fan
light kit flashes 3 times.
