GIpro Mount
Instructions manual
Choose the proper shim
Insert the pin
Fasten the clamp
Disassemble the clamp. Separate the plastic shims
and unroll the thin shim. Depending on the target tube
diameter, select the corresponding shim and place on
the handlebar.
Slide the pin into place, making sure the threaded hole
is aligned with the bolt hole.
Tighten the bolt with an
M5 hex (Allen) wrench
to secure the clamp on
the bar in the desired
position.
Wind the arm around the handlebar then close.
If a plastic shim is used, rotate it to the correct
position.
Fully adjustable handlebar mount for GIpro
Place the clamp on the bar
Thick
Thin
21-23mm (7/8”) : Thick Shim
24-26mm (1”)
: Thin Shim
27-29mm (9/8”) : Without Shim
