healing HHT894, Руководство пользователя

Страница: 25 / 30

25
TROUBLESHOOTING
Check your receiver with the suggestions below.
PROBLEM SUGGESTION
No Power Check the power cord is plugged in - at both ends.
No Reception Check operational antenna cable is properly connected.
Receiver not responding to the
Remote Control Unit. Check Remote Control batteries and battery contacts.
Ensure room lighting is not compromising IR signals.
The receiver is not responding
to the remote control or front
panel keys.
Disconnect the receiver’s mains power. Wait about 1
minute and power the unit up again. You may need to
reset to Factory Default and rescan.
I can see the menu but cannot
view any channels
First check a functional Antenna is properly connected
Then scan for Digital channels available in your area by
selecting Main Menu, Scan, Auto and Start.
Receiver on but I can’t see
Video or Audio
Check the required AV or HDMI cables are properly
connected
– at both ends.
After Scanning I cannot see all
of the channels available in my
area. Your antenna system may need to be updated for Digital
reception by an experienced specialist.
One or more of my channels
“breakup” while viewing.
This also indicates that your antenna may need
professional attention.
The message “N o Signal ”
displays when a scanned
channel is selected.
The signal for this service is too weak to be displayed.
As this is a high sensitivity receiver this also suggests your
antenna system needs professional attention.
No Audio
i. Check the Red and White audio leads from the
receiver are properly connected.
ii. Check the Mute is not activated on the receiver.
iii. Check the receiver’s volume level is high enough.
Receiver does not display
“Closed Captions” or
“Teletext”
Allow 30 sec’s to commence. Not all programs include
Closed Captions. Teletext is broadcast by 7 network
and some regional broadcasters.