healing HHM897 HD Digital Terrestrial TV Receiver - Operating Manual
18
Connector: Modulator RF Output
Use this connection method for televisions that do not have any video inputs.
Note: The factory default Modulator channel is UHF channel 38.
Note: If you need to use different UHF channel (choice of 21 to 69), refer to RF Modulator
Set Up on page
23.
You will require a separately purchased RF Lead.
This connection provides Video and Audio.
a. Connect the RF lead to the MODULATOR RF OUTPUT connector on the rear of the
receiver and to the ANTENNA IN connector on your television.
b. Connect your Aerial lead to the ANTENNA IN Connector on the rear of the receiver.
C. Connect mains power to the back of your receiver using the supplied IEC C7 figure 8
power lead
D. RF Sound Mode: B/G is the correct sound mode and it is set as a factory default.
