HE-VA Tip-Roller XL, Руководство по эксплуатации

Страница: 9 / 48

GB Tip-Roller XL 12,3 – 15,3 m 26-03-2019
8
Back to the table of contents
Spring Board
The spring board is adjustable by the means of
the cylinders mounted in the horns for the
spring board bar.
If the roller is mounted with two Spring-Board
bars, it is possible to adjust the angle to the
surface individually by the top link (figure 6).
Transport
At changeover for transport, the roller is tipped totally backward by pressurising the tip cylinder.
Now pressurise the wing cylinder so that the side sections turn forward, towards the stop on the
transport fittings of the chassis.
When both sides lie in parallel with the chassis, they are lowered down into the transport cradles by
releasing the pressure of the tipping cylinder.
Now relieve the hydraulics totally, and the roller is ready for transport.
Rolling
Speed: max. 10 km/h.
When turning, drive in wide curves as far as possible. The turning should be performed no sharper,
than all roller rings are still rotating forward.
Only lower the wheels when making ready for transport position.
Do not drive over any large stones, which are not moveable.
Do not operate the machine, if any people** are at risk in the dangerous area.*
When persons are at risk in the dangerous area (e.g. when doing adjustments, maintenance or
connect or disconnecting), the following points must be met:
1. Lower the machine on solid ground
2. Hydraulics must be relieved.
Figur 6