HE-VA Tip-Roller XL, Руководство по эксплуатации

Страница: 7 / 48

GB Tip-Roller XL 12,3 – 15,3 m 26-03-2019
6
Back to the table of contents
IMPORTANT: Check that the male quick couplings of the hydraulic hoses, mounted by the
factory, fits the female end of the tractor.
Now connect the hydraulic hoses, in the hydraulic outlets of the tractor. Coloured tags are mounted
at the quick-couplings, which refers to the different functions as:
Folding Tipping SAT-system Support leg Spring Board
Blue Red Yellow Black Green
Start engine and raise the support leg.
Warning

Do never transport the roller at any time when the middle section roller is decended to
ground and wing sections are in transport positions.

Drive carefully when driving off an on road/field. Be aware of ditches along the road and
holes in dirt tracks due to center of gravety is reasonable high.

Watch out in traffic to be sure there is space enough for the turning radius when turning.
Transport to work position
Changing from transport to work position and opposite, the roller must at all times be positioned
horizontally, and the tractor must be able to move freely.
Now pressurise the tip cylinder (figure 3), so that the side sections are tipped free of the transport
cradles (figure 1). Then the side sections, are turned out by means of the wing cylinder (figure 2).
Now the roller is hydraulically tipped into working position by means of the tip cylinder (figure 3).
Figur 1
Figur 2