HE-VA Disc-Roller Contour, Руководство по эксплуатации

Страница: 10 / 72

Disc-Roller Contour 4,5 – 5,5 – 6,5 m 20-09-2020
10
Back to the table of contents
Start-up of the machine
General Information
The machine is supplied as standard in transport position. At start-up, attach the machine to the
tractor.
Important:
The machine requires three double-acting outlets.
The hoses for the drawbar - / wheel cylinder are provided with
red cable straps.
The hoses for the folding cylinder are provided with
blue cable straps.
The hoses for the disc cylinder are provided with
green cable straps.
Attachment, Mounted Model
1. Reverse the tractor to the machine and attach.
2. Connect all hydraulic hoses to the tractor outlets.
3. Lift the machine to maximum transport height.
Attachment, Trailed Model
1. Reverse the tractor to the machine.
2. Connect all hydraulic hoses to the tractor outlets.
3. Pressurise the drawbar - and the wheel cylinder (red) so that the machine
drawbar is lifted to the suitable height.
4. Then reverse the tractor and attach the machine.
5. Now lift the machine to maximum height.
Transport position to workposition
1. Important: When unfolding the side sections, the locking claw must first
be relieved by activating the folding function, until the side sections meet
the stop at the center frame.
Next, when the unfolding function is activated,
the locking claw then first will open, after which the side sections are
unfolding.
2. When the side sections are completely unfolded, let go of the hydraulic handle
and the machine is ready for use.
Always set the tractor’s flow control on MAX, to make sure that the side
sections will follow each other.
3. Unfold the edge equipment to working position.
4. Now lift and lower the discs to the required working depth.
Check that the towing hook height is between 500 and 550 mm.
Check that the male quick-couplings of the Disc-Roller fit the
female quick-couplings of the tractor.