HDG Turbotec 50 L, Руководство по эксплуатации

Страница: 67 / 100

6 Using the heating system – Heating up and reloading the heating system
67
The desired value is set.
5. Press the Arrow button.
The target boiler temperature is assumed.
6. Press the Arrow button.
The sub-menu closes and “
Heat production off
” appears in
the display again.
The boiler target temperature is set.
See section “6.3 Structure of the menus” in this chapter for more
information.
F
UEL SELECTION
During start-up the combustion is generally set to the fuel to be used.
If a different fuel is used, the parameters must be reset for the new
fuel. Otherwise, unforeseen faults can occur in the combustion and
operation which may damage material goods or even present a
danger of injury or death.
6.6 Heating up and reloading the heating
system
Caution!
Every switch of fuel type, e.g. from spruce wood to beech wood,
requires a resetting of the boiler to the changed requirements of
the fuel!
Only allow authorised specialists to make adjustments to the
parameters.
Caution!
Hot surfaces!
Contact with the hot surfaces of the boiler can lead to burns.
Wait until the boiler has cooled down before touching uninsulated
components.
Warning!
Danger of asphyxiation due to carbon monoxide!
If the boiler is operating, carbon monoxide can be emitted through
the open filling hatches.
Do not leave the filling hatch open any longer than necessary.
Check that the hatches are closed every time you heat or reload.