HDG Turbotec 50 L, Руководство по эксплуатации

Страница: 59 / 100

6 Using the heating system – Overview of the controls and display components
59
6 Using the heating system
6.1 Overview of the controls and display
components
1 Heat production on indicator
2 Reloading indicator
3 Fault indicator
4 Text display
5 Heat production on/plus button
6 Heat production off/minus button
7 Re-activation button for the safety temperature limiter (STB)
8 Arrow button
9 Reload button
The HDG Lambda Control 1 control panel is located on the top of the
HDG Turbotec.
Through the control unit, you can regulate the HDG Lambda
Control 1 system and call up information on the current processes.
D
ISPLAY
The display shows the selected information and settings. In the
operating mode “Heat production on”, the display is switched on and
active. In the operating mode “Heat production off”, the display
switches off after 15 minutes. It can be switched on again by pressing
any button.
In section “6.3 Structure of the menus” in this chapter, all
selectable information and parameters are listed.
“H
EAT PRODUCTION
ON
”
INDICATOR
The “ Heat production on ” indicator (1) lights up when the combustion
process is started by pressing the “ Heat production on ” button (5), or
when the process starts automatically (if the flue gas temperature is
sufficient). The indicator goes dark when the combustion process is
stopped via the “
Heat production off” (6) button, or when the process
is automatically stopped due to lack of fuel.
Figure 6/1 - Control unit for HDG Lambda Control 1
6
5
7
1
2
3
4
8
9