HBM WTX120, Руководство по эксплуатации

Страница: 104 / 550

SupervisorMode
102
A4500-1.1 HBM: public
WTX120
10.2.16 Minimum start weight (Min. Start w.)
When this value is specified, the dosing process is not started if the current
gross value is less than this minimum start weight. Use this command and the
empty weight to define the range in which dosing is to start.
Information
This setting is ignored for a downward weighing operation.
10.2.17 Coarse flow cut-off point (Crs.Fl.off)
The coarse flow cut-off point must not be higher than the fine flow cut-off point.
After entering the target weight, the coarse flow cut-off point is automatically
set to 50% of the target weight if no coarse flow cut-off point is set. If optimiza­
tion is activated (parameter P1 > 0), the coarse flow cut-off point is tracked au­
tomatically. The coarse flow cut-off point must not be higher than the fine flow
cut-off point.
The minimum fine flow defines a minimum clearance from the fine flow cut-off
point where appropriate:
Coarse flow cut-off point
max
=
fine flow cut-off point – minimum fine flow
10.2.18 Coarse monitor (Crs. Monitor)
The option is used to monitor breakage (sack breakage) during the coarse flow
phase. Enter the increase in weight you expect per time interval (Coarse moni­
tor) in a normal filling process. At the end of the coarse flow lockout time, the
increase is checked after each time interval (Coarse monitor). If the weight in­
crease rate is not exceeded, the fact is interpreted as a breakage of the con­
tainer being filled, and dosing is aborted. The coarse flow monitor is only active
during the coarse flow phase.